Much better! As you can see near perfect.

Before I go into any detail, let me please thank each and every person who commented on my last post. Reddit was my social media of choice way back when I first got this printer, and I recall having an issue then… And the advice on reddit was, nonexistent. within a few minutes of my post yesterday I had several thought out answers. And to my surprise, not one of them were simply “go buy x printer”.

So once again thank you for being such a good community!

Now regarding the print… The bed was cleaned with 99% IPA, I hadn’t realized just how superficial a lot of the marks on the print bed were! Came up a treat with alcohol!

I modelled a print to basically stretch across almost the entire width of the print bed, so that I could do a few iterative tests quickly. Simply cleaning the bed definitely increase the adhesion.

Next I bumped up the temperature of both the print head and bed. 220, and 85 dropping to 75 after 10 or so layers. Now this seemed a fraction higher than I would be happy with, but you can’t argue with results? And I did use a few different methods to double check the temperatures involved and they were relatively close.

More is a proof of concept at this point, i made a relatively dilute PVA solution and wiped it across the surface… Definitely overkill but by this point the print was adhering perfectly.

But I’d like to share with everyone here, a revelation. Using only cutting edge techniques, that is, my eyes… I read the label on the side of the spool which quite clearly said PETG. Which might explain a little bit of my difficulty 😂

Thanks again to everyone in the community.