nieceandtows@programming.dev to 3DPrinting@lemmy.worldEnglish · 4 days agoWhat is the problem here?programming.devimagemessage-square27fedilinkarrow-up138arrow-down10
arrow-up138arrow-down1imageWhat is the problem here?programming.devnieceandtows@programming.dev to 3DPrinting@lemmy.worldEnglish · 4 days agomessage-square27fedilink
minus-squareThePantser@sh.itjust.workslinkfedilinkEnglisharrow-up24arrow-down1·edit-23 days agoToo close, level the bed and increase the Z offset until the smoosh is right. Also since it looks like it’s in different places you should do a probe calibration to adjust for uneven surface.
minus-squareJoelk111@lemmy.worldlinkfedilinkEnglisharrow-up2arrow-down1·2 days agoIn some places it’s too close, but in many places (like the top) it’s way too far away.
minus-squareRichard Wonka@slrpnk.netlinkfedilinkEnglisharrow-up1·6 hours agoIt may have a probe levelling grid active that’s out of whack.
minus-squarespitfire@lemmy.worldlinkfedilinkEnglisharrow-up2·3 days agoAlso preheating and waiting before bed leveling helps. These beds are wobbly. I’ve put a glass bed on top of the factory one on my K1
Too close, level the bed and increase the Z offset until the smoosh is right.
Also since it looks like it’s in different places you should do a probe calibration to adjust for uneven surface.
In some places it’s too close, but in many places (like the top) it’s way too far away.
It may have a probe levelling grid active that’s out of whack.
Also preheating and waiting before bed leveling helps. These beds are wobbly. I’ve put a glass bed on top of the factory one on my K1