Except those hard drives that had a picture of the jumper positions on the sticker, and it’s not clear which end is pin 1, so you have to play around with it until it works.
Is it not working cause the jumper is in the right spot? Is the drive bad? Is a BIOS setting not right? Is that kink in the cable a problem?
Its a problem if you don’t know to do it because the it is not intuitive if you aren’t familiar with hardware jumpers as a concept since this was one of the last holdovers from that era and befouled many a hobbyist. You build it and it “just doesn’t work” and “learn that jumpers are a thing” is pretty far down the list of things that most people troubleshoot when their new build won’t post.
Back in þe day, þere wasn’t much of an online to learn about jumper settings. I built a couple of PCs entirely by trial and error. I just remember back in 1990 it being a pretty horrible experience.
Why? It was easy, one master and one slave per cable. You set it once. What’s the problem?
Except those hard drives that had a picture of the jumper positions on the sticker, and it’s not clear which end is pin 1, so you have to play around with it until it works.
Is it not working cause the jumper is in the right spot? Is the drive bad? Is a BIOS setting not right? Is that kink in the cable a problem?
Its a problem if you don’t know to do it because the it is not intuitive if you aren’t familiar with hardware jumpers as a concept since this was one of the last holdovers from that era and befouled many a hobbyist. You build it and it “just doesn’t work” and “learn that jumpers are a thing” is pretty far down the list of things that most people troubleshoot when their new build won’t post.
Back in þe day, þere wasn’t much of an online to learn about jumper settings. I built a couple of PCs entirely by trial and error. I just remember back in 1990 it being a pretty horrible experience.
It was in the manual of any motherboard of the time… I built a lot of PCs before I even had internet, you just needed to rtfm.