Added a PEI plate for my Artillery Genius using bull clips, and after leveling the leveling/adhesion test print comes out like this. Is this just me leveling the bed too close to the nozzle, or is it the pei plate not heating up as much as the original glass bed? It’s at 60c btw
It’s most likely an error with the nozzle height. The PEI plate not heating up enough shouldn’t cause the adhesion in the photo above (and this is not a first layer problem, as the error is not at a uniform height). Additionally, a few lines are very faintly visible on the plate where they shouldn’t be, indicating nozzle height. Make sure that it is easy to move a piece of paper between the nozzle and the PEI plate when adjusting the height, feeling only a very small amount of pressure as you do so.
Yeah looks like the plate was not fully flat to begin with. Making it attach fully flat to the glass bed made things a lot better