Hoo boy I had it going way too fast. I had it moving at 150mm/s. I very strongly suspect this is about 90% of my problem. Layer quality already seems vastly improved a few layers in at 50mm/s. I very much appreciate the insight!

I haven’t run PLA on this printer. This is actually my second one, I modded my first one to the point of unusability. Maybe starting back with PLA is a good idea.

I’ll try dropping temps and see what I get. Thank you!

I haven’t had issues with curling but the enclosure is pretty new. The room is pretty variable with temps. The windows are old and maybe a little leaky.

Word. I’ll give that a go, thank you.

They’re sequential, so the values above and below yours are valid SSNs of people born in the same hospital around the same time.

This would make it trivially easy to get access to records you shouldn’t