“You need to buy this special heater pad to break the screen adhesive!”
No, I think you will find that in fact I don’t.
You must log in or register to comment.
Holy shit. I do a fair bit of small electronics repair on the side, the cost of a decent heat pad is about half that of a 3d printer… This may be what finally inspires me to get a 3d printer.
This is an amazing tip tbh. Never thought of using it for that.
Has anyone else found a use for their 3D printer that wasn’t exactly listed on the label?
Not from the 3D printing world, but sometimes I’d use our heating plate to reheat pizza LOL! Gotta make sure to clean the surface really well afterwards though.
Sounds like a job for tin foil or parchment paper
Fair enough. I just ended up placing it on a paper towel, then cleaned the surface with rubbing alcohol afterwards.
How about all three? Really make sure you don’t get that thing dirty.
I used to use the heated bed to brew tea while I was modeling. Poly makes a good cup.
I know a guy whose cat will take naps on it.
Used to have problems with the cat sneaking up while preheating, and being very intent on not getting off. (Even with the cold hot end poking him. It was… hilarious. Took an old i3 and sacrificed the build plate to solve the issue though.)
They need an enclosure
it really was hilarious watching the cat stubbornly refuse to move out the way as the bed moved back and forth and the hot end poked it. the cat had this most baleful look like it was being martyred by the machine.
(Yes, the friend was careful not to hurt the cat.)
Can I use it to warm up a sex toy? Asking for me.
Just 3d print one and grab it while it’s fresh and warm.
I realize this is a joke…
But don’t do this. Really. The fdm layers are unhygienic, and there’s a not-insignificant risk of things snapping off and leading to awkward emergency room visits.
A better solution is printing a 2 part mold and casting silicone.
deleted by creator
You can process the inside to be smooth (sanding, priming. If you have a solvent - acetone for abs, as an example. And mold release.)
Even just using a filler/primer should be enough
I was really impressed by the lulzbot manual mentioning this! Its also important to consider that most 3d prints can be sensitive to water unless sealed too.
I’m just gonna assume some one printed a butplug, had it snap off leading to said emergency room visit and they tried to sue lulzbot.
Who is this someone you’re talking about, FuglyDuck ?
Opening phones and heating burritos :)
And melting gallium when I 3D print moulds to make some silly metal objects (probably not so smart next to so much aluminium extrusion)
Wax is cheaper than gallium I think
Oh I know, I just have a few hundred grams of it since I like collecting elements, so I recast it into something funny when I’m bored
Sound’s fun. I’ve been meaning into getting into a 3d printing to casting process to make metal objects.
